Set of Heavy Duty Front Half Shafts & CV Joints to suit:
The Kits consists of : 2 x front shafts 2 x CV"s 2 x CV boots 4 x boot clips 2 x shaft clips. As the D2 has a "open knuckle" type front axle a much larger diameter CV join has been possible. This increased diameter not only allows a much thicker wall of the CV bell but also allows the use of bigger balls which reduce stresses and also allows us to increase the halfshaft from the small stock 32 spline to the much larger 24 spline| same as the 24 spline at the diff end. From product testing on a hydraulic test rig it was shown that the stock CV"s fail at 3700 ft/lbs; when testing the heavy duty ones the shaft failed before the CV at 7460 ft/lbs - They over twice as strong. The shafts and CV"s are covered by a 5 YEAR warranty against failure.